Replace Chesterton S10 Single Cartridge Mechanical Seal With Good Performance

Replace Chesterton S10 Single Cartridge Mechanical Seal With Good Performance

Suggested Operation Limits:

Temperature:-20ºC-220ºC

Speed:<=16M/S

Pressure:<=2.5Mpa

Size:24mm-120mm/1"-4.750"

Combined Material:

Rotary Face:CAR/SIC/TC

Stat Ring:SIC//TC

The type seal can replace with Chesterton S10 single cartridge seal.

Features/Benefits:

1,Optimized seal faces balance low heat generation and distortion to handle high pressure and torques
2,Floating Throttle bushing for maximum safety is standard

3,Delivers greater performance and value

Recommended Applications:

1,Process Pumps
2,Other Rotating Equipment
A cartridge seal is a completely self-contained design requiring no assembly prior to installation.The operating position of the seal faces are preset, eliminating detailed, exacting measurements and possible damage or contamination.The S10 Single is a matched pair of high-performance, robust seals that make standardization easy.

Double end, multiple springs, balanced, independent rotary direction, still structure, clamp transmission and cartridge seal. The compensation components are assembled into the flange and the elastomers protects the springs from the mediums to make sure the springs will not be jammed. Multiple springs make the loads on the seal faces balanced. The second end seal at the sealant side accomplish the second sealing and prevent the leakage of the mediums and sealants. The sleeve are supported by the elastomers on the shaft and there is no axial movement and no damage to the shaft. The seal faces are close to the rotor and have high cooling and lubrication efficiency. The special design of this seal can work with counter pressure and there are diversion trenches inside the flange so that the cooling effects are evenly distributed. This seal has to work with flush system and the sealant pressure should be 0.1 - 0.3 MPa and flow rate should be 3 - 8 L per minute.